How to properly attach the Cambox to your helmet?

This step is very important, please read carefully and follow our instructions to ensure a proper bonding of your attachment to its support!

Jim

Last Update a year ago

⚠️ CAUTION !

To ensure a perfect bonding of the attachment to your support, please check the following points:


✅ my helmet has been in temperate (15° mini) and not wet for more than 4 hours

✅ my fixation has been in temperate (15° mini) and not humid for more than 4 hours

✅ the surface where I will glue my fixation is clean, not wet and not greasy

✅ before sticking my fastener, I position it on my helmet or visor to take my bearings

✅ once glued, wait about 4 hours before attaching or detaching your camera to ensure proper gluing


Let's go, a few seconds are enough!


Before removing the protective film from your hook-and-loop fastener, we recommend that you place it on your helmet or visor, in order to remember its appropriate location. Then meticulously remove the protection, taking care not to put your fingers on the self-adhesive part.


Install the hook-and-loop fastener perfectly centered on your helmet or visor, then press hard on its entire surface to ensure a good bonding on its support


Present your Cambox® horizontally, centered on your helmet or visor, and place it on your hook-and-loop fastener.


Finally, apply pressure with your fingers to the 3 parts of your Cambox®, as shown above.


Was this article helpful?

8 out of 8 liked this article

Still need help? Message Us